Repair and Toyota Corolla car operation - 7.2.5. A being switched rope//Toyota the Corolla of 1992-1998 /

Toyota Corolla

1992-1998 of release

Repair and car operation



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmissions
   + 7.1. Mechanical transmission
   - 7.2. Automatic transmission
      7.2.1. Specifications
      7.2.2. Diagnostics
      7.2.3. Replacement of epiploons
      7.2.4. Butterfly valve rope
      7.2.5. A being switched rope
      7.2.6. The switch blocking inclusion of a starter by included transfer
      7.2.7. Transmission fastening
      7.2.8. Removal and transmission installation
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



7.2.5. A being switched rope

Removal and installation

PERFORMANCE ORDER
1. Disconnect a rope from the switching lever on a transmission, for this purpose turn off a nut (a photo at the left). Then remove switching rope from an arm located on a forward part of a transmission, for this purpose take a clip (a photo on the right).
2. Remove the central console.
3. Turn off fixing screws of the display panel of the lever of gear shifting (are specified by shooters a photo at the left), lift the panel and get a lighting bulb (a photo on the right). Adhere the panel to the gear shifting lever so that it did not disturb you at work.
4. Get to the check (to a photo at the left) and disconnect a rope from the gear shifting lever (a photo on the right).

5. Remove a fixing clip from a first line of the basis of the lever of gear shifting.
6. Stretch a rope via the plug in a body partition.
7. Installation is carried out upside-down removals.
8. After completion of installation adjust a rope.

Adjustment

PERFORMANCE ORDER
1. Turn off a nut on the lever of switching of a transmission.
2. Take away the lever to the right against the stop, then return it on two divisions back to the provision of neutral transfer.
3. Transfer the gear shifting lever in the car to the provision of neutral transfer.
4. Having a little pressed on the lever towards backing transfer, reliably twirl a nut.
5. Check transmission work, having switched the gear shifting lever through all provisions (try to start the engine by various transfers – the starter should join only by the included parking or neutral transfer).