Toyota Corolla

1992-1998 of release

Repair and car operation


Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmissions
   + 7.1. Mechanical transmission
   - 7.2. Automatic transmission
      7.2.1. Specifications
      7.2.2. Diagnostics
      7.2.3. Replacement of epiploons
      7.2.4. Butterfly valve rope
      7.2.5. A being switched rope
      7.2.6. The switch blocking inclusion of a starter by included transfer
      7.2.7. Transmission fastening
      7.2.8. Removal and transmission installation
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



7.2.6. The switch blocking inclusion of a starter by included transfer

Adjustment

PERFORMANCE ORDER
1. If the engine is started, when the lever of gear shifting is in the provision of any of transfers, except parking or neutral, the switch blocking inclusion of a starter, it is necessary to adjust.
2. Put the car on the hand brake and block back wheels. Lift a forward part of the car and establish it on support. Include neutral transfer.
3. Disconnect the connection socket from the switch and turn off bolts of fastening of the switch.
4. Connect щупы an ohmmeter to switch plugs on the socket of connection and rotate the switch while the ohmmeter will not show chain short circuit that testifies that it is in the provision of neutral transfer. Then twirl fixing bolts.

Replacement

PERFORMANCE ORDER
1. Disconnect a wire of the negative plug of the accumulator.
Prevention

If the stereoplayer of your car has coding system, check, whether you know a code of activation of a player before an accumulator detachment.
2. Include neutral transfer.
3. Turn off a nut and remove the switching lever.
4. Disconnect the connection socket.
5. By means of a screw-driver, unbend a uvula on an engraving washer under a nut, fixing the switch to a valve axis.
6. Turn off an engraving nut and remove an engraving washer and simple washers.
7. Turn off fixing bolts and remove the switch from an axis.
8. For switch installation, combine axis edges with cut edges in the switch and put on it an axis. Establish simple washers, an engraving washer and a fixing nut. Tighten a fixing nut and bend a uvula of a washer of the Engraver.

9. Turn the switch so that the line of neutral situation (1) was combined with a flute (2). Then twirl bolts and connect the connection socket.
10. Establish the switching lever, connect a wire of the negative plug of the accumulator and check, that the engine was not started, if any of transfers, except neutral and parking is included. If it is necessary, carry out the adjustment which procedure is described above.