Toyota Corolla

1992-1998 of release

Repair and car operation



Toyota Corolla
+ 1. Maintenance instruction
- 2. Maintenance
   2.1. Specifications
   2.2. Arrangement of knots and details
   2.3. Check of level of liquids
   2.4. Check of a condition of tires and pressure in tires
   - 2.5. Servicing through each 5000 km or 3 months
      - 2.5.1. Check and restoration of level of liquid
         2.5.1.1. System of a hydraulic actuator of a steering
         2.5.1.2. Automatic transmission
      2.5.2. Replacement of oil and oil filter
   + 2.6. Servicing through each 12000 km or 6 months
   + 2.7. Servicing through each 24000 km or 12 months
   + 2.8. Servicing through each 50000 km or 2 years
   + 2.9. Servicing through each 100000 km or 4 years
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



2.5. Servicing through each 5000 km or 3 months

2.5.1. Check and restoration of level of liquid

2.5.1.1. System of a hydraulic actuator of a steering

PERFORMANCE ORDER
1. Unlike purely mechanical steering in a steering with the hydraulic booster the liquid which level is required to be checked over time is used.
2. The tank of the pump of the hydraulic booster is located or on the right side of a motor compartment, behind a tank of a stekloomyvatel, or in a back right corner of a motor compartment (it is specified by an arrow), near the index of level of oil in the engine.
3. Check of level of liquid is carried out on the idle engine when forward wheels are in the provision of driving on a straight line.
4. Wipe pure rags a tank and a tank stopper. It is necessary to prevent hit of dirt or alien subjects in a tank at check.
5. Turn out a stopper, and having shipped a finger in liquid, check liquid temperature.
6. Depending on tank type check of level of liquid is carried out in two ways. If the tank of the pump of the hydraulic booster is taken out on the right wall of a motor compartment, level of liquid can be observed through a transparent wall of a tank on which control marks are put. On those cars in which the tank is mounted directly on the engine, for check of level of liquid a stopper of a tank it is built in щуп.
7. For check of level of liquid it is necessary to turn on and get a tank stopper together with built in shchupy, to wipe щуп pure rags and again to screw a stopper. Then again turn out a stopper and check level on edge of a film of liquid on щупе. On tanks of both types level of liquid should be in the top part of the range designated by Hot (if liquid to the touch hot), or in the top part of a range of Cold (if liquid to the touch cold). Keep in mind that control marks of Hot and Cold are put on the opposite sides of a tank or щупа. Fall of level of liquid below the bottom mark for the corresponding thermal condition of liquid is not allowed. Liquid level strongly changes depending on temperature therefore it should be checked, when liquid hot or cold.
8. If necessary add liquid in a tank mouth through a funnel.
9. The frequent dolivka of liquid indicates a podtekaniye in hoses of the hydraulic booster, in unions of hoses, in the pump of the hydraulic booster, and also in the steering mechanism, need of careful check and malfunction elimination.