Toyota Corolla

1992-1998 of release

Repair and car operation


Toyota Corolla
- 1. Maintenance instruction
   1.2. Codes of models
   1.3. Control panel
   + 1.4. Combination of devices
   + 1.5. Governing bodies and instrumentations
   + 1.6. Start-up of the engine and driving
   1.7. Specifications
   1.8. Adjusting data, refueling capacities and liquids
   - 1.9. Possible malfunctions
      1.9.1. Engine start in extreme conditions
      1.9.2. Wheel replacement
      1.9.3. Detection of a place of a leak
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



1.9. Possible malfunctions
GENERAL INFORMATION

If the engine is not started and the starter does not rotate

If the car is equipped with automatic transmission, be convinced that the lever of the selector is in the situation Park or Neutral.

Open a cowl and be convinced of purity of poles of the storage battery and reliability of fastening of plugs.

Include headlights and try to start the engine. If at start of the engine of a headlight burn very dimly, the main cause of failure of start-up is the discharged battery. Start the engine from the battery of other car, observing a start-up order in an emergency situation.

If the engine is not started at normally working starter

Whether there is a fuel in a tank?

Whether there is a moisture on details and devices of electric equipment of the engine?

Switch off ignition and wipe places of a congestion of moisture a dry rag. Put water-repellent aerosol means (WD-40 or equivalent) on sockets.

Check

Arrangement of sockets of fuel system and ignition system

PERFORMANCE ORDER
1. Check reliability of connection of the sockets A, B, C, D (cм. fig. An arrangement of sockets of fuel system and ignition system) at the switched-off ignition. If there is a suspicion on moisture hit, process water-repellent aerosol means of WD-40.
2. Check reliability of connection of high-voltage wires (A) with spark plugs.
3. Check reliability of connection of high-voltage wires (B) with a cover of the distributor of ignition
4. Check, that all sockets of system of ignition (for example, I I will corrode on the distributor (C)) were dry and if necessary put water-repellent means.
5. Check purity of poles of the storage battery and reliability of fastening of plugs (D).
6. Especially attentively check the low-voltage socket of the coil of ignition and high-voltage wires.