Toyota Corolla
- 1. Maintenance instruction
1.2. Codes of models
1.3. Control panel
+ 1.4. Combination of devices
+ 1.5. Governing bodies and instrumentations
+ 1.6. Start-up of the engine and driving
1.7. Specifications
1.8. Adjusting data, refueling capacities and liquids
- 1.9. Possible malfunctions
1.9.1. Engine start in extreme conditions
1.9.2. Wheel replacement
1.9.3. Detection of a place of a leak
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment
|
Some features of installation of a wheel can differ depending on car model. For example, places of placement of a spare wheel and a jack on cars of various models differ. However the general order of works is identical to all cars.
Preparation
| PERFORMANCE ORDER |
| 1. At a wheel puncture immediately stop the car, considering traffic conditions. |
| 2. Establish the car on an equal firm surface on sufficient removal from a lane. |
| 3. If necessary include a signal of an emergency stop. |
| 4. If you have a sign of an emergency stop, establish it for the prevention of other drivers. |
| 5. Put the car on the hand brake and include the first or reverse gear (the situation Park in cars with an automatic tranmissiya). |
| 6. Block a wheel diagonalno opposite replaced, – two big stones for this purpose will approach. |
| 7. If the soil soft, in order to avoid immersion of a jack substitute under it a board. |
|
Replacement
| PERFORMANCE ORDER |
|
1. Remove the decorative panel from the interior of a luggage compartment and remove a jack. |
|
2. Lift a cover of a trunk floor and turn on the holder of a spare wheel. Get a spare wheel, a bag with tools and a key for nuts of wheels. Substitute the blocks entering into a set of tools, under a wheel diagonalno opposite to the replaced. |
|
3. Remove a decorative cap of a wheel by means of a shovel entering into a set of tools. Then a wheel key weaken on a half of turn of a nut of fastening of a replaced wheel. |
|
4. Establish a jack on the firm soil under the strengthened section of a threshold of a body (lift the car, establish a jack only under this place) |
|
5. Rotate the jack handle clockwise until the wheel will not appear raised over the earth, unscrew nuts of fastening of a wheel and remove a wheel. |
|
6. Establish a spare wheel, turn and tighten fastening nuts. Lower the car and tighten fastening nuts in the specified sequence. |
| 7. Establish a decorative cap. |
| 8. Clean from under a block wheel. |
| 9. Put in a luggage carrier a jack and tools, observing correctness of placement. Check pressure in the tire of the established wheel. If pressure low, or you have no manometer, moving on small speed, reach the next garage and pump up the tire to normal pressure. |
| 10. Immediately hand over the damaged wheel (or the tire) in repair. |
|
|
|