Toyota Corolla

1992-1998 of release

Repair and car operation



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
- 5. Fuel, exhaust systems
   5.1. Specifications
   5.2. Order of performance of a decompression of fuel system
   5.3. Fuel pump and pressure of fuel
   5.4. Removal and installation of the fuel pump
   5.5. Fuel level sensor
   5.6. Gasoline pipe lines and joints
   5.7. Fuel tank
   5.8. Cleaning and repair of a fuel tank
   5.9. Air filter
   5.10. Cable of a drive of a butterfly valve
   5.11. System of electronic injection of fuel (EFI - system)
   5.12. Check and replacement of EFI units - systems
   5.13. Service of an exhaust system
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



5.7. Fuel tank

GENERAL INFORMATION

Fuel tank and accompanying details

1. Protective guard of an inlet gasoline pipe line
2. Gryazeotrazhatel
3. Tapes of fastening of a tank
4. Pipe of a jellied mouth
5. Laying
6. A stopper of a jellied mouth with laying
7. Cover and casing of a pipe of a jellied mouth
8. Lock of a stopper of a jellied mouth
9. Mouth hose
10. Filter
11. Average section of the exhaust silencer
12. Laying
13. The warmed-up sensor of oxygen (only for engines 7A-FE)
14. Back heatinsulating guard
15. Fuel tank
16. Final tube of a gasoline pipe line
17. Hose of a return gasoline pipe line
18. Cover of a viewing opening of a body floor
19. Pillow of a back seat
20. Arrangement of amortiziruyushchy pillows of a fuel tank

Removal

PERFORMANCE ORDER
1. To remove a fuel tank expediently after its full devastation. On some cars in a tank the drain stopper is provided. In the absence of a drain stopper devastate a tank a trip with the subsequent operation of the engine idling, or merge gasoline through a hose with the rubber manual pump (is available on sale). A mouth gasoline not to suck away!
2. Unscrew a stopper of a jellied mouth of a tank to remove residual pressure.
3. Disconnect the battery from weight.
4. If the tank is filled, merge gasoline in capacity specially intended for gasoline.
5. Lift the car and establish on supports.
6. Before starting to remove a tank study its design, configuration and fastening on the car (see fig. A fuel tank and accompanying details.
7. Remove average section of the exhaust silencer and a heatinsulating guard from the car (see subsection 5.13).
8. Establish under a tank a floor support, having laid between a platform of a support and a tank a board not to damage a tank.
9. Disconnect tubes of giving and removal of fuel and a hose of a pipe jellied горлрвины.

Prevention

After a detachment muffle hoses and tubes to exclude dirt hit.


11. Unscrew bolts of fixing tapes of a tank.
12. Lower a tank so that it was possible to disconnect the socket of conducting and the grounding tire from the pump and the fuel level sensor (if wires and the tire are not disconnected not so).
13. Remove a tank.

Installation

The tank is established upside-down.