Repair and Toyota Corolla car operation - 8.2.6. The switch blocking start of the engine//Toyota the Corolla of 1992-1998 /

Toyota Corolla

1992-1998 of release

Repair and car operation



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
- 8. Coupling and semi-axes
   8.1. Specifications
   - 8.2. Coupling
      8.2.1. Coupling elements
      8.2.2. Vyzhimna bearing and fork of switching off of coupling
      8.2.3. Main cylinder of a drive of switching off of coupling
      8.2.4. Working cylinder of a drive of switching off of coupling
      8.2.5. Hydraulic system of a drive of switching off of coupling
      8.2.6. The switch blocking start of the engine
   + 8.3. Semi-axis
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



8.2.6. The switch blocking start of the engine

Check

PERFORMANCE ORDER
1. Check height of installation of a pedal of coupling, its free wheeling and a free wheeling of a pusher (see subsection 8.2).
2. Check, that the engine could not be started, when the pedal of coupling is released. Check, that the engine was started if to squeeze out a coupling pedal up to the end.
3. If the switch does not work how is described, adjust it, or if it is necessary, replace.
4. The switch blocking start of the engine (1), is located under the dashboard on an arm before a coupling pedal. Find it and disconnect the connection socket.
5. By means of an ohmmeter check, that the switch carried out a current when it is included, he should not carry out a current when it is switched off (a pedal of coupling is squeezed out).

6. Check, that the switch did not carry out a current when it is switched off (a pedal of coupling is released).
7. If the switch is faulty, replace it.

Replacement

PERFORMANCE ORDER
1. Turn off a nut closest to a plunzher of the switch, and unscrew the switch. Disconnect the connection socket.
2. Installation is carried out upside-down removals. The switch is self-regulating therefore to regulate it it is not necessary.
3. Again check, that the engine was not started, if the pedal of coupling is not squeezed out up to the end, and was started, if is squeezed out.