| 1. Oil in a case of differential and transmission liquid are subject to periodic replacement. |
| 2. Previously get transmission liquid (see subsection 2.1). |
| 3. For works supports are necessary for the car, wrenches, the pallet with capacity not less than 2,5 l, newspapers and pure rags also. |
| 4. Liquid should be merged at once after a trip as with hot liquid pollution by extraneous components best of all are removed. |
Prevention
The temperature of transmission liquid can reach 175 ° With therefore work in gloves.
|
| 5. Right after a trip on purpose to warm up liquid lift the car and establish on supports to provide access to drain jams of transmission and differential. |
| 6. Place under the car all necessary tools and accessories, trying not to concern hot details. |
|
7. Substitute the pallet under a drain stopper of transmission and unscrew a stopper a six-sided key. Before removal of a stopper be convinced that the pallet is established strictly under a stopper as liquid will start to follow under a pressure. After running off of liquid wrap a stopper and tighten. |
|
8. Weaken at first forward bolts of fastening of the pallet of transmission then back. |
|
9. Hook the pallet a screw-driver and merge the liquid rest. After running off of liquid unscrew bolts completely and lower the pallet. |
|
10. Unscrew bolts of fastening of the filter, disconnect a bracket (is available on a part of cars). When lowering the filter be careful, as it contains the liquid rest. Pay attention to a zalipshy magnet (it is specified by an arrow). A magnet surely clear and establish in the transmission pallet. |
| 11. Put the new filter, attach a bracket and wrap bolts. Tighten bolts with the set moment (see subsection 2.1). |
|
12. Carefully clear pallet laying of a laying material. Remove magnets, having remembered their arrangement, wash out the pallet and magnets in pure solvent and dry the compressed air. Surely clear magnets and establish in the transmission pallet. |
| 13. Lay on the pallet new laying, establish the pallet and wrap bolts in a former order. Tighten bolts with the set moment (see subsection 2.1). |
|
14. Find a drain stopper of a case of differential. Substitute under a stopper the pallet, unscrew a stopper a six-sided key and merge oil. After oil running off densely tighten a stopper. |
|
15. At removal of a stopper be careful, as oil will start to follow under a pressure. |
| 16. Fill in in differential fresh liquid (see subsection 2.1). Liquid fill in to bottom edge of an opening (see subsection 2.5.1.2). |
Prevention
Liquid not to pour. The automatic transmissiiya and differential are separate units.
|
| 17. Lower the car. |
18. On the stopped engine add transmission liquid through a tube of the index of level. Fill in liquid through a funnel in the small portions, constantly checking level shchupy (see subsection 2.5.1.2). Check level having waited for time necessary for running off of liquid in a case of transmission. |
| 19. Start the engine and transfer the selector lever from situation P to situation L, then again in situation P, put the car on the hand brake. |
| 20. Idling check level of transmission liquid. Add to Cool mark on щупе. |