Toyota Corolla

1992-1998 of release

Repair and car operation


Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
- 12. Electric equipment
   12.1. Safety locks
   12.2. Burned-through crossing points
   12.3. Automatic switches
   12.4. Relay
   12.5. Breakers of indexes of turns / alarm system
   12.6. The combined switch
   12.7. The switches established on a steering column
   12.8. Lock of ignition and lock drum
   12.9. Switch of a heater of back glass
   12.10. Heater of back glass
   12.11. Radio receiver and loudspeakers
   12.12. Aerial
   12.13. Bulbs of headlights of head light
   12.14. Headlights of head light
   12.15. Replacement of bulbs
   12.16. System of day inclusion of headlights
   12.17. Engine of screen wipers
   12.18. Instrument guard
   12.19. Sound signal
   12.20. System cruise control
   12.21. System of the central lock
   12.22. System of window regulators
   12.23. Rear-view mirrors with the electric drive
   12.24. Safety airbag
   + 12.25. Electroschemes



12.13. Bulbs of headlights of head light
GENERAL INFORMATION
Prevention

On these models the halogen bulbs filled with gas under pressure are established, and the bulb can burst if to scratch its surface or to drop a bulb. Carry goggles and address with bulbs accurately if probably, holding a bulb only for the basis. Do not concern a bulb surface fingers as fat from your skin can lead to an overheat of a bulb and its premature exit out of operation. If you concerned a bulb surface, clear it by means of methyl alcohol.

If the stereoplayer of your car has coding system, check, whether you know a code of activation of a player before an accumulator detachment.

Replacement
PERFORMANCE ORDER
1. Open a cowl.
2. Disconnect a wire of the negative plug of the accumulator.
3. If it is necessary, remove an air inlet for receiving access to a reverse side of the holder of a bulb.
4. Press on a rychazhok and disconnect the connection socket from the holder of a bulb.
5. Turn the holder of a bulb counter-clockwise and remove it from the headlight panel (if to look behind). Trying not to concern some bulb glass naked fingers, establish a cartridge with a new bulb on a headlight and turn it on an hour hand for fixing.
6. Connect the socket of connection and a wire of the negative plug of the accumulator. Check work of a headlight of head light, then close a cowl.