Toyota Corolla

1992-1998 of release

Repair and car operation

Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
- 12. Electric equipment
   12.1. Safety locks
   12.2. Burned-through crossing points
   12.3. Automatic switches
   12.4. Relay
   12.5. Breakers of indexes of turns / alarm system
   12.6. The combined switch
   12.7. The switches established on a steering column
   12.8. Lock of ignition and lock drum
   12.9. Switch of a heater of back glass
   12.10. Heater of back glass
   12.11. Radio receiver and loudspeakers
   12.12. Aerial
   12.13. Bulbs of headlights of head light
   12.14. Headlights of head light
   12.15. Replacement of bulbs
   12.16. System of day inclusion of headlights
   12.17. Engine of screen wipers
   12.18. Instrument guard
   12.19. Sound signal
   12.20. System cruise control
   12.21. System of the central lock
   12.22. System of window regulators
   12.23. Rear-view mirrors with the electric drive
   12.24. Safety airbag
   + 12.25. Electroschemes

12.6. The combined switch

GENERAL INFORMATION

Prevention

On these models the airbag of safety which can reveal is established (it will be filled with air) when it is connected to the accumulator. Disconnect a wire of the negative plug of the accumulator and wait for at least two minutes before the work beginning with a safety airbag.

If the stereoplayer of your car has coding system, check, whether you know a code of activation of a player before an accumulator detachment.

Removal and installation

PERFORMANCE ORDER

1. Disconnect a wire of the negative plug of the accumulator.
2. Disconnect a safety airbag (see subsection 12.24) and remove a steering wheel (see subsection 10.16).
3. Remove a casing of a steering column (see subsection 11.22) and the bottom panel of furnish (subsection 11.23).
	4. Turn off fixing screws (are specified by shooters) combined switch.
	5. Walk along a plait of wires down to the connection socket, get wires from fixing clips if they are established, then remove the switch from a steering column and disconnect the connection socket (it is specified by an arrow).
6. Installation is carried out upside-down removals. Being guided by instructions, adjust a spiral wire before installation of a steering wheel (see subsection 10.16).