Repair and Toyota Corolla car operation - 1.5.39. Radio receiver AM-UKV with electronic control//Toyota the Corolla of 1992-1998 /

Toyota Corolla

1992-1998 of release

Repair and car operation



Toyota Corolla
- 1. Maintenance instruction
   1.2. Codes of models
   1.3. Control panel
   + 1.4. Combination of devices
   - 1.5. Governing bodies and instrumentations
      1.5.1. Keys for the car
      1.5.2. Immobilizer system (recognition of a code of start-up of the engine)
      1.5.3. Locking of doors
      1.5.4. Electric equipment of doors
      1.5.5. Drive of glasses
      1.5.6. Trunk lid
      1.5.7. Back door
      1.5.8. Cowl
      1.5.9. Stopper of a jellied mouth of a fuel tank
      1.5.10. The hatch with the electric drive
      1.5.11. Adjustment of forward seats
      1.5.12. Addition of a back seat
      1.5.13. Head restraint
      1.5.14. Seat heater
      1.5.15. Safety cushions for the driver and the passenger
      1.5.16. Elements of system of additional damping at failure
      1.5.17. Adjustment of an inclination of a steering wheel
      1.5.18. Rear-view mirror
      1.5.19. Headlights and indexes of turns
      1.5.20. Adjustment of a beam of light of headlights
      1.5.21. Signal of an emergency stop and regulator of illumination of devices
      1.5.22. Back antifog lamps
      1.5.23. Lamps of internal lighting
      1.5.24. Inclusion of a cleaner and windscreen washer
      1.5.25. Inclusion of a cleaner and washer of back glass
      1.5.26. Heater of back glass
      1.5.27. Index of level of fuel
      1.5.28. The index of temperature of cooling liquid
      1.5.29. Voltmeter
      1.5.30. Tachometer
      1.5.31. Counter of the total passable way
      1.5.32. Light indexes and warning signals
      1.5.33. Lock of ignition and lock of a steering column
      1.5.34. 3-step automatic transmission
      1.5.35. 4-step automatic transmission
      1.5.36. Mechanical transmission
      1.5.37. System of blocking of interaxal differential
      1.5.38. Hand brake
      1.5.39. Radio receiver AM-UKV with electronic control
      1.5.40. An AM-VHF-radio tape recorder with electronic control
      1.5.41. Adjustment of the direction of a stream of air
      1.5.42. Hours
      1.5.43. Lighter and ashtray
      1.5.44. Perchatochny box
      1.5.45. The container for trifles
      1.5.46. A framework for luggage transportation (a body the Versatile person)
      1.5.47. Trunk lid
      1.5.48. Superimposed rug of a floor
      1.5.49. Period of a running in of the car
      1.5.50. Fuel
      1.5.51. Threefold catalytic converter
      1.5.52. Oil expenditure engine
      1.5.53. Brakes
      1.5.54. Ruled cargo placements in a luggage carrier
      1.5.55. Identification data of the car
   + 1.6. Start-up of the engine and driving
   1.7. Specifications
   1.8. Adjusting data, refueling capacities and liquids
   + 1.9. Possible malfunctions
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



1.5.39. Radio receiver AM-UKV with electronic control

GENERAL INFORMATION

1. Handle of turning on of the receiver, regulator of loudness and balance of the left and right loudspeakers
2. Control button:
3. Control with fall of frequency of reception
4. Control with increase of frequency of reception
5. Button of a choice of an AM mode or WC (VHF)
6. Buttons of a choice of ranges
7. Display
8. Button of a choice of a stereo / the mono
9. Button of automatic control
10. Timbre adjustment

 Using radio receiver

PERFORMANCE ORDER
1. Turn on the receiver, having turned the PWR.VOL handle clockwise.
2. Adjust loudness, turning the PWR.VOL handle.
3. Be adjusted on the necessary station.
4. For reception of VHF (FM) - radio stations be switched to a mode of reception of VHF (FM), choose a stereo mode - or monophonic reception.
If transfer on VHF stereo is accepted, the receiver will automatically be switched to stereo reception, at the same time on the display there will be a ST symbol. If a signal weak, be switched to a monophonic mode, having pressed the corresponding button. On the display there will be a MONO symbol.
5. Adjust a timbre and balance.
6. To switch off the receiver, turn the PWR.VOL handle counter-clockwise.

 Control for station

PERFORMANCE ORDER
1. For a choice mono - or stereoreception press the LM/U button. On the display there will be LMW or UKW symbols.
2. Be adjusted on the necessary station by means of one of offered below ways. On the display there will be a value of frequency of control.
Control in a program mode
3. Press the button of a choice of station which was in advance brought in memory. The receiver will automatically be adjusted on this station, and on the display button number will be displayed.
Mode of continuous search
4. Press at the same time on both parties of the TUNE button and wait a continuous sound signal. The receiver will start to carry out automatically search of the next station with higher or lower frequency of a broadcasting. After a consistent reception control stops. By the subsequent pressing of the button search will proceed to a consistent reception of the following station.
5. If because of too weak signal it is not possible to be adjusted after single scanning of all range of frequencies, search will proceed, but at hypersensibility, and on the display there will be a symbol of DX. After station reception control automatically stops.
Manual control
6. Press at the same time on both parties of the TUNE button for a while, not exceeding 0,5 pages. By each pressing of the button occurs перескок to frequency on which the broadcasting is possible.

 Control programming

PERFORMANCE ORDER
1. Be adjusted on the necessary station.
2. Press the button of a choice of station and wait a sound signal. Thus the station will automatically join by pressing this button, which number will appear on the display.
3. On each button it is possible to remember one AM station and one VHF station. To bring in memory control for new station, repeat the procedure described above. Control for the programmed station is erased at food shutdown (a detachment of the battery, a safety lock peregoraniya etc.).

 ARI station reception (road information)

PERFORMANCE ORDER
1. Press the LM/U button. On the display there will be an UKW symbol.
2. Press the VF button. The receiver will be switched to a mode of reception of ARI on the display there will be a VF symbol.
3. Be adjusted on the necessary station broadcasting API information. After control for ARI station on the display there will be a SK symbol.
4. For ARI broadcasting cancellation repeatedly press the VF button.

Timbre control

It is provided with TONE handle turn.

Balance control.

Pull on itself the PWR handle. VOL also turn.