Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
+ 3.1. Petrol engines
+ 3.2. Diesel engine
- 3.3. Engine electric equipment
3.3.1. Specifications
3.3.2. Battery
3.3.3. Power cables
3.3.4. Ignition system
3.3.5. Ignition coil
3.3.6. Ignition distributor
3.3.7. Check and installation of the moment of ignition
3.3.8. Block of electronic ignition
3.3.9. Induction sensor
3.3.10. System of a charge of the battery
3.3.11. Generator
3.3.12. Generator details
3.3.13. System of start-up of the engine
3.3.14. Starter electric motor
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment
|
Removal
| PERFORMANCE ORDER |
| 1. Disconnect the battery from weight. |
| 2. Disconnect sockets from the distributor. |
| 3. Find on a distributor cover the cast figure "1". It is a label of a high-voltage conclusion of the 1st cylinder. If the label on a cover is absent, find the corresponding conclusion on a cover on a wire from the 1st cylinder. |
4. Uncover the distributor and, having turned the crankshaft, establish a begunok opposite to a high-voltage conclusion of the 1st cylinder (see subsection 3.1.1.2). |
|
5. Put a label on the bottom edge of the case of the distributor, it is direct under the termination a begunka so that the label in accuracy coincided with a begunok. Put also labels on the case of the distributor and on a head of cylinders to provide the correct installation of the distributor at assembly. |
| 6. If the design provided fastening by two bolts with zaplechik for a flange, release these bolts (to provide a free wheeling of the distributor) but completely do not turn on.
|
|
7. Unscrew a bolt of fastening of the distributor, then submit the distributor in the horizontal direction and get it. |
|
Prevention
Crankshaft turn after removal of the distributor from the engine is not allowed. Otherwise drawing of labels becomes senseless.
Installation
Prevention
If the crankshaft nevertheless turned after distributor removal, establish the piston of the 1st cylinder in VMT of a step of compression (subsection 3.1.1.2) and сориентируйте a begunok and the distributor case.
| PERFORMANCE ORDER |
|
1. Replace a sealing ring on the distributor case. |
|
2. Combine a ledge on the distributor coupling with a flute on the case. |
| 3. Insert the distributor into the engine, it is exact сориентировав the case on the put labels.
|
| 4. If the distributor is not established in a place, once again check the labels put on the basis of the case of the distributor and on the engine before dismantling. Establish the distributor precisely on these labels. Check also orientation a begunka, the label on a begunka should coincide with a label on the basis of the case which was put before dismantling. |
| 5. Wrap a bolt (ы) distributor fastenings. |
| 6. Further installation is carried out upside-down.
|
| 7. Check installation of the moment of ignition (see subsection 3.3.7), tighten a bolt of fastening of the distributor. |
|
|
|