Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
+ 3.1. Petrol engines
+ 3.2. Diesel engine
- 3.3. Engine electric equipment
3.3.1. Specifications
3.3.2. Battery
3.3.3. Power cables
3.3.4. Ignition system
3.3.5. Ignition coil
3.3.6. Ignition distributor
3.3.7. Check and installation of the moment of ignition
3.3.8. Block of electronic ignition
3.3.9. Induction sensor
3.3.10. System of a charge of the battery
3.3.11. Generator
3.3.12. Generator details
3.3.13. System of start-up of the engine
3.3.14. Starter electric motor
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment
|
Prevention
Procedure of installation of the moment of ignition is applicable to almost all cars which are considered in this Management. However, if the order of installation of the ignition, specified in the information plate of the car, differs from described below, act according to the plate instruction.
Check
| PERFORMANCE ORDER |
|
1. Connect a tachometer (1), being guided by the instruction of the manufacturer of the device (2 – the battery). |
|
2. Find the diagnostic socket (it is specified by an arrow) and close накоротко conclusions Е1 and TE1. |
|
3. At the switched-off ignition connect a stroboscope, being guided by the instruction of the manufacturer of the device (on a photo the set for check and installation of the moment of ignition is represented). Almost all stroboscopes eat from the battery. Besides, on a high-voltage wire of the 1st cylinder the winding of the induction sensor of a stroboscope puts on.
|
|
Installation
| PERFORMANCE ORDER |
| 1. In most cases it is necessary to disconnect vacuum hoses and to muffle them. For this purpose cast caps of various diameters are provided. |
| 2. The lamp flash operated by an impulse of a current of electric breakdown of a candle of the 1st cylinder. Radiates the directed beam of light at the spark category in a candle of the 1st cylinder. Wires of a lamp are connected according to the instruction of the manufacturer. |
| 3. On some cars access to a bolt of fastening of the distributor is complicated, therefore the bent key similar represented in picture above is applied. |
| 4. Find labels of the moment of ignition on a forward cover and on a crankshaft pulley. |
|
5. Start the engine and warm up to normal working temperature (the top hose of a radiator should be hot). Be convinced that turns of idling of the engine correspond to norm (see subsection 5.1). Direct lamp flash light on a scale of the moment of ignition on a forward cover (drawing). The label on a pulley of the crankshaft should coincide with a label of 10 degrees to VMT on a scale. If necessary weaken a bolt of fastening of the distributor and slowly turn the distributor before coincidence of labels on a pulley and on a scale. Tighten a bolt of fastening of the distributor and again check installation of the moment of ignition. |
| 6. Remove a crossing point from the diagnostic socket and be convinced that the corner of an advancing of ignition corresponds to norm (see subsection 3.3.1). |
| 7. Switch off ignition and remove a stroboscope set from the engine. |
|
|
|