Toyota Corolla

1992-1998 of release

Repair and car operation


Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines
   + 3.2. Diesel engine
   - 3.3. Engine electric equipment
      3.3.1. Specifications
      3.3.2. Battery
      3.3.3. Power cables
      3.3.4. Ignition system
      3.3.5. Ignition coil
      3.3.6. Ignition distributor
      3.3.7. Check and installation of the moment of ignition
      3.3.8. Block of electronic ignition
      3.3.9. Induction sensor
      3.3.10. System of a charge of the battery
      3.3.11. Generator
      3.3.12. Generator details
      3.3.13. System of start-up of the engine
      3.3.14. Starter electric motor
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



3.3.9. Induction sensor
GENERAL INFORMATION

Check of resistance of the induction sensor of the distributor

1. An arrangement of conclusions on cars with the built-in block of electronic ignition (Toyota and GEO respectively)
2. An arrangement of conclusions on cars with the block of electronic ignition of external installation (Toyota and GEO respectively)
  3. An arrangement of conclusions on cars with the built-in block of electronic ignition (Toyota and GEO respectively)
4. An arrangement of conclusions on cars with the block of electronic ignition of external installation (Toyota and GEO respectively)

Check

PERFORMANCE ORDER
1. Disconnect the socket from the distributor and measure resistance between conclusions of the induction sensor (See a photo Check of resistance of the induction sensor of the distributor).
2. Compare results of measurements to the values specified in the section "Specifications". If the measured resistance differ from standard values, the sensor replace.

Gap check between the sensor and a rotor
PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Remove the distributor (see subsection 3.3.6).
3. Brass shchupy measure a gap between a rotor and a ledge of the induction sensor. Compare result to the standard. If the gap differs from standard, the distributor replace, as the gap is not subject to adjustment. The increase in a gap against norm is usually caused by wear of the bearing of the distributor.

Replacement

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Remove the distributor (see subsection 3.3.6).
3. Remove the ignition coil (see subsection 3.3.5).
4. Unscrew adjusting screws of the induction sensor.
5. Remove from the distributor the induction sensor.
6. Remove the condenser and replace it.
7. Installation is carried out upside-down.