Toyota Corolla

1992-1998 of release

Repair and car operation

Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Petrol engines
      - 3.1.1. Repair work without engine dismantle from the car
         3.1.1.1. Specifications
         3.1.1.2. Installation of the piston of the 1st cylinder in MWT of a step of compression
         3.1.1.3. Cover of a head of the block of cylinders
         3.1.1.4. A soaking-up collector
         3.1.1.5. Final collector
         3.1.1.6. Gear belt
         3.1.1.7. Forward epiploon of the crankshaft
         3.1.1.8. Cam-shaft epiploon
         3.1.1.9. Cam-shafts and pushers (engines of 1,3 l)
         3.1.1.10. Cam-shafts and pushers (l engines 1,6 and 1,8)
         3.1.1.11. Head of the block of cylinders
         3.1.1.12. Oil pallet
         3.1.1.13. Oil pump
         3.1.1.14. Flywheel (or leading disk of the hydrotransformer)
         3.1.1.15. Back epiploon of the crankshaft
         3.1.1.16. Engine mount details
      + 3.1.2. Dismantle and major maintenance
   + 3.2. Diesel engine
   + 3.3. Engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment

3.1.1.7. Forward epiploon of the crankshaft

Replacement

PERFORMANCE ORDER

1. Remove a gear belt and a leading gear wheel of the crankshaft (see subsection 3.1.1.6).
	2. Define depth of a press fitting of an epiploon, then get an epiploon from the case of the oil pump, having hooked it a screw-driver or other tool. At extraction of an epiploon do not damage an opening under an epiploon or a surface of a neck of the crankshaft (at crankshaft damage the new epiploon will leak).
	3. The epiploon which was in the use can be taken and more reliable way for what make an incision a sharp knife a working edge of an epiploon in the specified place.
4. Clear an opening under an epiploon in the case of the oil pump and slightly oil an external surface of a new epiploon for the engine or universal greasing. Working edges of an epiploon grease with greasing on the basis of a molybdenum disulfide.
	5. Carefully press a new epiploon into place by means of an opravka with a diameter a little smaller than diameter of an epiploon, and an internal directing opravka, or a big face head.
6. Be convinced that the epiploon evenly came into an opening on the same depth on which it was established before dismantling. In the absence of an opravka it is possible to use a piece of a pipe of big diameter. After installation be convinced that the provision of a spring of an epiploon is not broken.
7. Establish a gear wheel of the crankshaft and a gear belt (see subsection 3.1.1.6).
8. Start the engine and be convinced of lack of a leak of a forward epiploon.