Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Systems of cooling, heating
4.1. Specifications
4.2. Antifreeze
4.3. Thermostat
4.4. Fan and relay of turning on of the fan
4.5. Radiator and broad tank
4.6. The pump of cooling liquid
4.7. The sensor of temperature of cooling liquid
4.8. Fan block
4.9. Heater radiator
+ 4.10. Control panel heater and conditioner
4.11. Vlagootodelitel of the conditioner
4.12. Compressor
4.13. Condenser
4.14. Evaporator and broad valve
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment
|
Removal
| PERFORMANCE ORDER |
| 1. Depressurize the conditioner and remove a coolant in service of car-care center of Toyota or in a specialized workshop. |
| 2. Disconnect the battery from weight. |
| 3. Remove from the compressor a belt (see subsection 2.6.4). |
|
4. Disconnect from the compressor the conducting socket (it is specified by a big arrow), unscrew bolts of flange connections (two small arrows) and disconnect coolant tubes from the compressor. |
|
5. Unscrew bolts of fastening of the compressor (shooters specified two bottom bolts, two more bolts are in the top part of the compressor) and remove the compressor. |
| 6. If the new compressor is established, execute all procedures specified in the enclosed instruction. Before installation check oil level in the compressor. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is carried out upside-down. Replace laying, specially prednazanachenny it is concrete for type of your compressor, oil the laying, recommended for your conditioner. |
| 2. Fill the conditioner with a coolant in the same workshop in which depressurization and coolant removal were carried out. |
|
|
|