| 1. The block of the fan is located in salon, over the right niche for feet. If the fan does not turn on, check reliability and purity of all connections, and also serviceability of a safety lock. Be convinced that the battery is completely charged. |
| 2. Remove a slip, a door of a perchatochny box and the right bottom panel (see subsection 1.5.44). |
| 3. If the fan electric motor does not work, disconnect the socket from the electric motor, turn the ignition key in the situation ON (the engine not to start) whether and check there is a tension on contact of a black wire when the switch of the fan is in the situation ON. If tension is absent, the power-supply circuit of system of ignition is faulty. |
| 4. If tension from the battery is, connect the socket to the fan and concern a black-and-white wire (from a reverse side of the socket) a crossing point connected to weight. If the electric motor is not started, probable a cause of failure is malfunction of the electric motor. |
|
5. Disconnect the socket (it is specified by an arrow). Connect electric motor conclusions through a fusible insert to the battery and with weight. If the electric motor is not started, replace the electric motor. |
| 6. If the electric motor is serviceable, but does not work at any speed of rotation, the switch on the control panel the heater / conditioner is faulty. Remove the control panel (see subsection 11.25) and check integrity of a chain of the switch at each position of the switch. |
|
7. If the electric motor works only at great speed rotations, check serviceability of the block of additional resistors of the electric motor of the fan which is located under the dashboard from a seat of the passenger. The place of installation of the block of resistors of the electric motor of the fan is specified by an arrow. Fastens two screws. |