Toyota Corolla

1992-1998 of release

Repair and car operation


Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Systems of cooling, heating
   4.1. Specifications
   4.2. Antifreeze
   4.3. Thermostat
   4.4. Fan and relay of turning on of the fan
   4.5. Radiator and broad tank
   4.6. The pump of cooling liquid
   4.7. The sensor of temperature of cooling liquid
   4.8. Fan block
   4.9. Heater radiator
   + 4.10. Control panel heater and conditioner
   4.11. Vlagootodelitel of the conditioner
   4.12. Compressor
   4.13. Condenser
   4.14. Evaporator and broad valve
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment


Бесплатно смотреть секс чат, секс чат смотреть бесплатно онлайн.
На сайте http://pr-ekb.ru сублимационная печать на футболках.

4.5. Radiator and broad tank

Removal and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Merge liquid in a vessel (see subsection 2.8.4).
3. Disconnect the top and bottom hoses of a radiator.
4. Disconnect a tank hose from a jellied mouth of a radiator.
5. Remove the fan.
6. On the cars equipped with automatic transmission, disconnect from a radiator of the union of tubes of a supply of liquid to a transmission cooler. Substitute the pallet for collecting the spilled liquid, muffle the union.
7. Remove two top arms of fastening of a radiator.
Prevention

In the lower part the radiator is established on two probes on which rubber plugs are dressed. Probes densely come into body openings.
8. Remove a radiator, having lifted it up. Do not lose thus rubber plugs which should be on a place before radiator installation. Be careful some the spilled liquid and sharp edges of a radiator.
9. Check existence of leaks from a radiator, mechanical damages, purity of internal channels. In need of repair address in a specialized workshop, or in service of car-care center of the dealer as will be necessary application special the equipment and technologies.
10. Remove insects and dirt from intercostal radiator spaces, having blown it the compressed air and having cleared a soft brush. When cleaning do not bend a radiator orebreniye.
11. The radiator upside-down is established. Be convinced available rubber plugs on assembly probes of a radiator.
12. After installation of a radiator fill system of cooling with liquid with the necessary ratio of water and antifreeze.
13. Start the engine and watch formation of leaks from all broken demountable connections. Warm up the engine to working temperature, being guided on heating of both hoses of a radiator. Again check level of cooling liquid, if necessary restore.
14. On the cars equipped with automatic transmission check level of transmission liquid, if necessary restore.

Broad tank

PERFORMANCE ORDER
1. On the majority of cars the tank simply gets from an arm close to the battery. Take aside a tee from a tank (it is specified by an arrow) and remove a tank from an arm (the right arrow).
2. Merge in a vessel liquid from a tank, examine a tank, check existence on it of cracks and pomyatost. At detection of signs of damages a tank replace.
3. The tank is established upside-down.