Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Systems of cooling, heating
4.1. Specifications
4.2. Antifreeze
4.3. Thermostat
4.4. Fan and relay of turning on of the fan
4.5. Radiator and broad tank
4.6. The pump of cooling liquid
4.7. The sensor of temperature of cooling liquid
4.8. Fan block
4.9. Heater radiator
+ 4.10. Control panel heater and conditioner
4.11. Vlagootodelitel of the conditioner
4.12. Compressor
4.13. Condenser
4.14. Evaporator and broad valve
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment
|
Removal
| PERFORMANCE ORDER |
| 1. Depressurize the conditioner and remove a coolant in service of car-care center of Toyota or in a specialized workshop. |
| 2. Remove a radiator (see subsection 4.9). |
|
3. Remove a decorative lattice (see subsection 11.26) and the right headlight (see subsection 12.14). Disconnect the union of tubes of a supply and branch of a coolant. To disconnect the right tube, unscrew a flange bolt (it is specified by an arrow). Muffle the disconnected tubes to prevent moisture hit. |
Prevention
The left joint is connected to a receiver (see subsection 4.11).
|
|
4. Unscrew two bolts of fastening of the condenser – on one from each party (the right bolt is shown). Displace the condenser back and remove from the car. |
|
Installation
| PERFORMANCE ORDER |
| 1. Establish the condenser and arms, wrap bolts. Be convinced of reliability of fastening of rubber pillows on the condenser. |
| 2. Attach coolant tubes, replace ring laying. If the new condenser is established, enter 4–6 g of fresh oil of recommended brand. |
| 3. Other details are established upside-down. |
| 4. Fill the conditioner with a coolant in the same workshop in which depressurization and coolant removal were carried out. |
|
|
|