Toyota Corolla

1992-1998 of release

Repair and car operation


Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
- 10. Suspension bracket and steering
   10.1. Specifications
   10.2. Rack of a suspension bracket (lobby)
   10.3. Suspension bracket rack
   10.4. Stabilizer of cross-section stability (a forward suspension bracket) and plug
   10.5. Suspension bracket lever
   10.6. Spherical hinges
   10.7. Rotary fist and nave
   10.8. Nave and nave bearing (a forward wheel)
   10.9. Stabilizer of cross-section stability (a back suspension bracket) and plug
   10.10. Rack of a suspension bracket (back)
   10.11. Longitudinal draft
   10.12. Cross-section drafts of a suspension bracket
   10.13. Nave and bearing (a back wheel)
   10.14. Arm of a nave of a back wheel
   10.15. Steering
   10.16. Steering wheel
   10.17. Tips of steering drafts
   10.18. Steering transfer
   10.19. Pump of system of strengthening of a steering
   10.20. System of strengthening of a steering
   10.21. Wheels and tires
   10.22. Adjustment of corners of installation of wheels
+ 11. Body
+ 12. Electric equipment



10.5. Suspension bracket lever

 Removal
PERFORMANCE ORDER
1. Turn off nuts of fastening of a wheel, lift a forward part of the car, establish it on support and remove a wheel.
2. Turn off a bolt and two nuts (are specified by shooters), suspension brackets fixing the lever to a rotary fist.
3. With the help ломика take away the suspension bracket lever from a rotary fist and remove the suspension bracket lever from the spherical hinge.
4. To release forward креплениерычага suspension brackets – remove a forward sharnirny bolt (it is specified by an arrow).
5. To release back fastening of the lever of a suspension bracket to a cross-piece on release models since 1996 – remove a back sharnirny bolt (it is specified by an arrow).
6. To release back fastening of the lever of a suspension bracket to a cross-piece on models of earlier years of release – turn off a nut, fixing a sharnirny bolt to an arm and the plug (see fig. Elements of the stabilizer of cross-section stability and lever of a forward suspension bracket).
Prevention

It is not necessary to turn off a nut and two bolts, fixing a lever arm
suspension brackets if only you do not need to replace the plug.
7. Remove the suspension bracket lever.

Survey

PERFORMANCE ORDER
Check the suspension bracket lever on existence of deformations and its plug on existence of wear tracks, having replaced them if it is necessary. Do not try to level the bent lever of a suspension bracket, replace it.

Installation
PERFORMANCE ORDER
1. Installation is carried out upside-down removals (see fig. Elements of the stabilizer of cross-section stability and lever of a forward suspension bracket).
2. Tighten all carving connections till the demanded moments of an inhaling specified in the section of technical characteristics at the beginning of this chapter.
Prevention

Before a twisting of sharnirny bolts, lift the external end of the lever by means of a jack to bring the lever into situation in which it is when the car costs on wheels.

3. Establish a wheel and acquire a nut of fastening of a wheel. Lower the car on the earth and tighten nuts till the demanded moment of an inhaling specified in the section of technical characteristics in the corresponding chapter.
4. It is recommended to check adjustment of forward wheels and if it is necessary, to adjust.