Toyota Corolla

1992-1998 of release

Repair and car operation


Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
- 10. Suspension bracket and steering
   10.1. Specifications
   10.2. Rack of a suspension bracket (lobby)
   10.3. Suspension bracket rack
   10.4. Stabilizer of cross-section stability (a forward suspension bracket) and plug
   10.5. Suspension bracket lever
   10.6. Spherical hinges
   10.7. Rotary fist and nave
   10.8. Nave and nave bearing (a forward wheel)
   10.9. Stabilizer of cross-section stability (a back suspension bracket) and plug
   10.10. Rack of a suspension bracket (back)
   10.11. Longitudinal draft
   10.12. Cross-section drafts of a suspension bracket
   10.13. Nave and bearing (a back wheel)
   10.14. Arm of a nave of a back wheel
   10.15. Steering
   10.16. Steering wheel
   10.17. Tips of steering drafts
   10.18. Steering transfer
   10.19. Pump of system of strengthening of a steering
   10.20. System of strengthening of a steering
   10.21. Wheels and tires
   10.22. Adjustment of corners of installation of wheels
+ 11. Body
+ 12. Electric equipment



10.6. Spherical hinges

 Replacement
PERFORMANCE ORDER
1. Turn off nuts of fastening of a wheel, lift the car and establish it on support. Remove a wheel.
2. Get to the check (if is available) from an opening of a bolt of the spherical hinge and turn off a nut (but do not remove it while).
3. Remove the spherical hinge from a rotary fist by means of the tool for division of spherical hinges. Grease a rubber cover with greasing and be accurate not to tear a cover.
4. Remove a nut from a bolt of the spherical hinge. The gap between a bolt of the spherical hinge and the CV JOINT is very small. To remove a nut, you should turn off it on one-two turn, to lower the hinge, again to turn off a nut on pair of turns etc. while the nut will not be turned off.
5. Turn off bolts and the nuts, fixing the spherical hinge to the suspension bracket lever. Remove the spherical hinge from the lever with the help ломика.
6. For installation of the spherical hinge, insert a hinge bolt into an opening of a rotary fist and acquire a nut, but do not twist it while up to the end. Do not insert a bolt up to the end into an opening, start to twist a nut as soon as the end of a bolt will seem from an opening, and then twist a nut, stretching a bolt through an opening.
7. Establish the spherical hinge on the suspension bracket lever, establish a bolt and nuts, having tightened them till the demanded moment of an inhaling (see subsection 10.1).
8. Tighten a nut of fastening of the spherical hinge to a rotary fist till the demanded moment of an inhaling (see subsection 10.1) and establish adjustable to the check. If the opening for checks in a bolt does not coincide with an opening in a nut, twirl a nut a little more to combine openings – do not turn off a nut in order that it was possible to insert adjustable to the check.
9. Establish a wheel and acquire a nut of fastening of a wheel. Lower the car on the earth and tighten nuts of fastening of a wheel till the demanded moment of an inhaling (see subsection 10.1).