Toyota Corolla

1992-1998 of release

Repair and car operation



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
- 10. Suspension bracket and steering
   10.1. Specifications
   10.2. Rack of a suspension bracket (lobby)
   10.3. Suspension bracket rack
   10.4. Stabilizer of cross-section stability (a forward suspension bracket) and plug
   10.5. Suspension bracket lever
   10.6. Spherical hinges
   10.7. Rotary fist and nave
   10.8. Nave and nave bearing (a forward wheel)
   10.9. Stabilizer of cross-section stability (a back suspension bracket) and plug
   10.10. Rack of a suspension bracket (back)
   10.11. Longitudinal draft
   10.12. Cross-section drafts of a suspension bracket
   10.13. Nave and bearing (a back wheel)
   10.14. Arm of a nave of a back wheel
   10.15. Steering
   10.16. Steering wheel
   10.17. Tips of steering drafts
   10.18. Steering transfer
   10.19. Pump of system of strengthening of a steering
   10.20. System of strengthening of a steering
   10.21. Wheels and tires
   10.22. Adjustment of corners of installation of wheels
+ 11. Body
+ 12. Electric equipment



10.9. Stabilizer of cross-section stability (a back suspension bracket) and plug

GENERAL INFORMATION

Prevention

On some models, probably, it will be necessary to lower a fuel tank for receiving free space, the sufficient stabilizer for removal of cross-section stability (see subsection 5.7).


Removal and installation

PERFORMANCE ORDER
1. Turn off nuts of fastening of back wheels. Lift a back part
the car also establish it on support. Remove back wheels.
2. Turn off nuts of fastening of a bar of the stabilizer (the fastening nut – is specified by an arrow) to connecting drafts. If the bolt rotates together with a nut, hold it by means of a face wrench.
3. Turn off bolts of fastening of clips of plugs of the stabilizer of cross-section stability (fastening bolts – are specified by shooters).
4. The stabilizer of cross-section stability now can be removed from the car. Remove fastenings from a stabilizer bar.
5. Check plugs on existence of wear tracks, on existence of consolidations, deformations, cracks or other damages and replace them if it is necessary. Also, check plugs of connecting drafts.
6. By means of a wire brush, clear places on a stabilizer bar on which plugs go. Installation is carried out upside-down removals. If it is necessary, oil plugs and U-shaped arms vegetable for simplification of installation (do not use oil oils or brake liquid as they will damage rubber of plugs).
7. For check of a condition of connecting drafts, be guided by instructions (see subsection 10.4).
8. Installation is carried out upside-down removals.