Toyota Corolla

1992-1998 of release

Repair and car operation



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines
   - 3.2. Diesel engine
      3.2.1. Specifications
      3.2.2. Replacement of a gear belt
      3.2.3. Removal of a head of cylinders
      3.2.4. Dismantling of a head of cylinders
      3.2.5. Partition of a head of cylinders
      3.2.6. Assembly of a head of the block of cylinders
      3.2.7. Installation of a head of cylinders
      3.2.8. Check and adjustment of gaps of valves
      3.2.9. Check of a compression of cylinders
      3.2.10. Pistons and rods
      3.2.11. Measurement of cylinders
      3.2.12. Assembly of pistons and rods
      3.2.13. Installation of pistons and rods
      3.2.14. Cranked shaft and flywheel
      + 3.2.15. Cooling system
      + 3.2.16. Greasing system
      3.2.17. Device of injection of diesel fuel
      3.2.18. Car operation on diesel fuel
      3.2.19. Fuel filter
      3.2.20. Fuel pump of a high pressure
      3.2.21. Nozzles
      3.2.22. Glow plugs
      3.2.23. Adjustment of a mode of idling
      3.2.24. Adjustment of the maximum turns
      + 3.2.25. Good advice to owners of the diesel engine
   + 3.3. Engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



3.2.19. Fuel filter

GENERAL INFORMATION

The fuel filter is replaced according to indications of the maintenance instruction and is subject to replacement if the precautionary lamp of the filter lights up, signaling that in the filter there is a water.

PERFORMANCE ORDER
1. Disconnect the socket from the switch of the filter and unscrew the switch by means of a trumpet key.
2. Unscrew the filter a key for the filter as it becomes at an otvorachivaniye of the oil filter. Completely unscrew the filter and remove a sealing ring.
3. Enclose a new sealing ring in a flute of the filter and fill in in it a little diesel fuel.
4. Screw the filter on a filter socle before emergence of notable resistance. From this situation tighten the filter on 3/4 turns, either a hand, or a key for the filter.
5. Screw the filter switch with new laying, tightening only a hand, instead of a key. Connect the socket.
6. Swing the handle of the manual pump from the top party of the filter before emergence of notable resistance. It is a sign of that the filter is completely filled.