Repair and Toyota Corolla car operation - 3.2.22. Glow plugs//Toyota Corolla of 1992-1998 /

Toyota Corolla

1992-1998 of release

Repair and car operation



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines
   - 3.2. Diesel engine
      3.2.1. Specifications
      3.2.2. Replacement of a gear belt
      3.2.3. Removal of a head of cylinders
      3.2.4. Dismantling of a head of cylinders
      3.2.5. Partition of a head of cylinders
      3.2.6. Assembly of a head of the block of cylinders
      3.2.7. Installation of a head of cylinders
      3.2.8. Check and adjustment of gaps of valves
      3.2.9. Check of a compression of cylinders
      3.2.10. Pistons and rods
      3.2.11. Measurement of cylinders
      3.2.12. Assembly of pistons and rods
      3.2.13. Installation of pistons and rods
      3.2.14. Cranked shaft and flywheel
      + 3.2.15. Cooling system
      + 3.2.16. Greasing system
      3.2.17. Device of injection of diesel fuel
      3.2.18. Car operation on diesel fuel
      3.2.19. Fuel filter
      3.2.20. Fuel pump of a high pressure
      3.2.21. Nozzles
      3.2.22. Glow plugs
      3.2.23. Adjustment of a mode of idling
      3.2.24. Adjustment of the maximum turns
      + 3.2.25. Good advice to owners of the diesel engine
   + 3.3. Engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



3.2.22. Glow plugs

GENERAL INFORMATION

The unique details relating to ignition, glow plugs which are used for initial heating of a mix of combustion are. On glow plugs tension after ignition key installation in position of heat moves. The supply voltage makes not less than 11,5 In and for some seconds of a candle more than 1000 are heated to temperature ° by S.Vremya of an incandescence depends on the current temperature of the engine. If the engine is not started at once, the chain of a current is broken off, but again becomes isolated, if the ignition key is again established in position of heat. Spark plugs are not under repair and at damages are replaced. Glow plugs settle down in a head of cylinders. Unscrew nuts from candles, and remove the remained details. Remove sockets of candles of an incandescence and turn out candles a head with the extension piece. At installation tighten glow plugs the moment of 13 N of m.