Toyota Corolla

1992-1998 of release

Repair and car operation



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines
   - 3.2. Diesel engine
      3.2.1. Specifications
      3.2.2. Replacement of a gear belt
      3.2.3. Removal of a head of cylinders
      3.2.4. Dismantling of a head of cylinders
      3.2.5. Partition of a head of cylinders
      3.2.6. Assembly of a head of the block of cylinders
      3.2.7. Installation of a head of cylinders
      3.2.8. Check and adjustment of gaps of valves
      3.2.9. Check of a compression of cylinders
      3.2.10. Pistons and rods
      3.2.11. Measurement of cylinders
      3.2.12. Assembly of pistons and rods
      3.2.13. Installation of pistons and rods
      3.2.14. Cranked shaft and flywheel
      + 3.2.15. Cooling system
      + 3.2.16. Greasing system
      3.2.17. Device of injection of diesel fuel
      3.2.18. Car operation on diesel fuel
      3.2.19. Fuel filter
      3.2.20. Fuel pump of a high pressure
      3.2.21. Nozzles
      3.2.22. Glow plugs
      3.2.23. Adjustment of a mode of idling
      3.2.24. Adjustment of the maximum turns
      + 3.2.25. Good advice to owners of the diesel engine
   + 3.3. Engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



3.2.4. Dismantling of a head of cylinders

PERFORMANCE ORDER
1. Clamp in a vice a head of cylinders for attached to one of hairpins of a final collector a bracket.
2. Remove a camshaft. Unscrew bolts of covers of bearings a cross on a cross from edges to the middle and remove covers.
3. Removal and installation of valves needs the special tool shown in drawing. Tighten the tool before compression of a spring and then remove crackers of valves. (For removal of valves it is possible to use and a piece of a tube.)
4. Take out cups of springs and a spring. Remove maslootrazhatelny caps from cores of valves and at once throw out, as they are subject to replacement. All details of each valve hold together.
5. Lay valves in the overturned cardboard box and near each valve write its number.
6. Remove all remained on a head of cylinders of a detail.