Repair and Toyota Corolla car operation - 1.6.19. Precautionary measures for cast aluminum disks//Toyota the Corolla of 1992-1998 /

Toyota Corolla

1992-1998 of release

Repair and car operation



Toyota Corolla
- 1. Maintenance instruction
   1.2. Codes of models
   1.3. Control panel
   + 1.4. Combination of devices
   + 1.5. Governing bodies and instrumentations
   - 1.6. Start-up of the engine and driving
      1.6.1. Check before engine start-up
      1.6.2. Check after engine start-up
      1.6.3. Driving receptions
      + 1.6.4. Trailer towage
      1.6.5. Actions at refusal of start-up of the engine
      1.6.6. Obligatory set of tools and spare wheel
      1.6.7. Wheel replacement
      1.6.8. Car towage
      1.6.9. Motor compartment
      1.6.10. Arrangement of safety locks
      1.6.11. Check of level of oil in the engine
      1.6.12. Choice of brand of oil
      1.6.13. Check of level of cooling liquid
      1.6.14. Composition of cooling liquid
      1.6.15. Pressure check in tires
      1.6.16. Replacement of tires
      1.6.17. Shift of wheels
      1.6.18. Installation of winter tires and chains
      1.6.19. Precautionary measures for cast aluminum disks
      1.6.20. Check of an external condition of the battery
      1.6.21. Check of level of electrolit
      1.6.22. Battery charging
      1.6.23. Check and replacement of safety locks
      + 1.6.24. Replacement of lamps
   1.7. Specifications
   1.8. Adjusting data, refueling capacities and liquids
   + 1.9. Possible malfunctions
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



1.6.19. Precautionary measures for cast aluminum disks

GENERAL INFORMATION

Throughout run of the first 1600 km check an inhaling of nuts of wheels.

After shift or replacement of a wheel check an inhaling of nuts of wheels throughout 1600 km of run.

When using chains be careful not to damage disks.

Nuts of fastening of disks should be firm, tighten nuts only a key intended for aluminum disks.


When balancing a wheel use only firm грузики (or equivalent) which fasten a rubber or plastic hammer.

Periodically check a condition of disks. At detection of damages a disk immediately replace.