Before the beginning of assembly prepare all necessary new spare parts, laying and consolidations, and also the following tools and adaptations:
– cтандартный tool kit;
– dinamometrichesky natural head 1/2;
– the adaptation for installation of piston rings;
– an opravka for an obzhatiya of piston rings;
– pieces of rubber or plastic hoses for clothing on bolts of a cover of a rod;
– plastic calibration wire of "Plastigauge";
– set щупов;
– file;
– fresh oil for the engine;
– assembly greasing or greasing on the basis of a molybdenum disulfide;
– hermetic;
– a compound for fixing of carving connections.
To save time and labor costs, assembly is recommended to be carried out in the following order. – piston rings (see subsection 3.1.2.16);
– a cranked shaft and radical bearings (see subsection 3.1.2.17);
– pistons assembled with rods (see subsection 3.1.2.19);
– a back epiploon of the crankshaft (see subsection 3.1.2.18);
– a head of cylinders and pushers (see subsection 3.1.1.11 and subsection 3.1.1.9);
– cam-shafts (see subsection 3.1.1.9);
– the oil pump (see subsection 3.1.1.13);
– a gear belt and gear wheels of a belt, a cover of a gear belt (see subsection 3.1.1.6);
– a maslopriyemnik (see subsection 3.1.1.12);
– the oil pallet see subsection 3.1.1.12);
– soaking-up and final collectors (see subsection 3.1.1.4 and subsection 3.1.1.5);
– a cover of a head of the block of cylinders (see subsection 3.1.1.3);
– a flywheel (a leading disk of the hydrotransformer) (see subsection 3.1.1.14); |