Toyota Corolla

1992-1998 of release

Repair and car operation

Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines
   - 3.2. Diesel engine
      3.2.1. Specifications
      3.2.2. Replacement of a gear belt
      3.2.3. Removal of a head of cylinders
      3.2.4. Dismantling of a head of cylinders
      3.2.5. Partition of a head of cylinders
      3.2.6. Assembly of a head of the block of cylinders
      3.2.7. Installation of a head of cylinders
      3.2.8. Check and adjustment of gaps of valves
      3.2.9. Check of a compression of cylinders
      3.2.10. Pistons and rods
      3.2.11. Measurement of cylinders
      3.2.12. Assembly of pistons and rods
      3.2.13. Installation of pistons and rods
      3.2.14. Cranked shaft and flywheel
      - 3.2.15. Cooling system
         3.2.15.1. Removal and installation of the water pump
         3.2.15.2. Thermostat
      + 3.2.16. Greasing system
      3.2.17. Device of injection of diesel fuel
      3.2.18. Car operation on diesel fuel
      3.2.19. Fuel filter
      3.2.20. Fuel pump of a high pressure
      3.2.21. Nozzles
      3.2.22. Glow plugs
      3.2.23. Adjustment of a mode of idling
      3.2.24. Adjustment of the maximum turns
      + 3.2.25. Good advice to owners of the diesel engine
   + 3.3. Engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment

3.2.15.1. Removal and installation of the water pump

GENERAL INFORMATION

The water pump – removal and installation

1. Right bracket of an engine mount
2. Top cover of a gear belt
3. Driving gear wheel of the fuel pump of a high pressure
4. Water pump

5. Laying
6. Fuel pump of a high pressure
7. Pulley of a cranked shaft
8. Bottom cover of a gear belt
9. Gear belt

Besides a gear belt, it is necessary to remove also fuel pump of a high pressure to provide access to the water pump.

PERFORMANCE ORDER

1. To merge liquid from cooling system.

2. Remove the fuel pump of a high pressure as it is described in subsection 3.2.20.

3. Remove an average cover of a gear belt.

4. Unscrew the water pump. It fastens on seven bolts. Pay attention to an arrangement of bolts as they have various length. Remove laying.

5. Installation is made upside-down. Surely establish new laying. Bolts tighten the moment of 18 N of m.

6. The fuel pump and a gear belt are established how is described in subsection 3.2.20 and subsection 3.2.2. Adjust a tension of a maple belt of the generator and fill in liquid in cooling system.