Toyota Corolla

1992-1998 of release

Repair and car operation


Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines
   - 3.2. Diesel engine
      3.2.1. Specifications
      3.2.2. Replacement of a gear belt
      3.2.3. Removal of a head of cylinders
      3.2.4. Dismantling of a head of cylinders
      3.2.5. Partition of a head of cylinders
      3.2.6. Assembly of a head of the block of cylinders
      3.2.7. Installation of a head of cylinders
      3.2.8. Check and adjustment of gaps of valves
      3.2.9. Check of a compression of cylinders
      3.2.10. Pistons and rods
      3.2.11. Measurement of cylinders
      3.2.12. Assembly of pistons and rods
      3.2.13. Installation of pistons and rods
      3.2.14. Cranked shaft and flywheel
      - 3.2.15. Cooling system
         3.2.15.1. Removal and installation of the water pump
         3.2.15.2. Thermostat
      + 3.2.16. Greasing system
      3.2.17. Device of injection of diesel fuel
      3.2.18. Car operation on diesel fuel
      3.2.19. Fuel filter
      3.2.20. Fuel pump of a high pressure
      3.2.21. Nozzles
      3.2.22. Glow plugs
      3.2.23. Adjustment of a mode of idling
      3.2.24. Adjustment of the maximum turns
      + 3.2.25. Good advice to owners of the diesel engine
   + 3.3. Engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and semi-axes
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



3.2.15.2. Thermostat
GENERAL INFORMATION

The thermostat is in the inlet union of system of cooling, that is before removal of the thermostat it is necessary to merge cooling liquid to height below the union. The thermostat is checked the same as on the petrol engine. The temperature of opening of the thermostat makes 80–82 ° With and at temperature 95 ° About the thermostat should open completely. Thus the pin should act on 8 mm from the thermostat.